Hey guys, Can someone help to find a English, US or dutch Manual for a Graupner MC?? It cam with a German one. email direct. Lehrer-Modul für mc/mc Graupner Required if an mc transmitter is to be used as teacher transmitter in conjunction with a pupil transmitter of. Assembly kit for installation DUPLEX TU transmit module into Graupner MC and MC trasnmitters.
|Published (Last):||20 January 2005|
|PDF File Size:||2.12 Mb|
|ePub File Size:||6.57 Mb|
|Price:||Free* [*Free Regsitration Required]|
manual Graupner MC10 – RC Groups
Front Plate mz Radio Control in carbon look and sticks Under the contacts following marks are fitted: On the printboard, between both sticks, you will find a male horizontal connector with 5 contacts in line, pointed to the right for the MC10, pointed downwards for the MC Find the nearest retailer.
If you cut the signal-wire and make the same connections as on the previous drawing, I suppose that you then obtain a “master”-radio. This cheap radio when found in second hand is very suitable for use as pupil-TX with a Futaba master: The Graupner FM Here you’ll find the adapted drawing for my site fig. Trim nuts for hand transmitters, 3x long and 2x short, So any owner of a MC with knowledge about the matter please advice Trim nuts for hand transmitters, 3x long and 2x short, blue Shipping workdays.
But even with my knowledge of German, I understand nothing of it lack of electronic knowledge. The person that send me an Graupmer on the 25th of september with a solution for connecting a Graupner to an EVO, graupber contact me again; your E-mail was accidently deleted by my anti-spam filter.
No IN-connection has been looked after.
Contest-S-Pult-JUNIOR mc/12 Graupner – Hobbydirekt
Two versions of this radio exists, the outer being identicalthe inner parts are different. Version 2 of the FM fig. Special design with length adjustment for transmitter mx- mz- mc- and all transmitters with a As both transmitters have an ggaupner PPM signal modulation, an inverter is required.
But on this website www.
Neck Strap for Transmitters Graupner mz-12PRO, mz-18, mz-24PRO, mz-32
PL from which only one wire is used, or by means of a servo connector. Graupner-overview I have no information regarding the buddy box interface that transforms the electrical signal into an optical signal. Here also no problem to use the radio as a pupil-TX. Transmitter cross over strap Grauner workdays. Windscreen for carbon sender console Shipping workdays.
Assembly Kit G10/12 (for Graupner MC 10/12 transmitters)
Probably the same can be done on all radios that can be equipped with the master-module ref. You better bought a radio where the buddy box is standard from factory Customers also bought Customers also viewed.
Version 1 of the FM fig. And for those who understood the principle, there couldn’t be any problem to arrange this radio as a pupil-radio: Wind Deflector for Transmitter Tray Shipping workdays.
The Ground and PPM OUT are to be found on a connector on the printed circuit board right from the connectors of the main channels 1 to 7. In the middle of the printed mcc10 with the electronic components you will find a male connector with 3 contacts.
Up to the visitors of this site to transmit me more information about type of connectors, place and other useful stuff. Special design with length adjustment for transmitter mx- mz- mc- and all transmitters with a central suspension device.
The connections as shown in fig. But I have no information on how to use this radio as a master-TX. You can choose for a positive or negative PPM modulation. My informant uses his FM as a pupil’s transmitter.
The CFK high load servo arm, 36mm 4pcs Shipping workdays.