Manufacturer name, Eltako. Manufacturer number, TLZEV+UC. GTIN, Country of origin, Germany. Customs tariff number, gThe Standardg TLZ12 8E 23 V UC replaces the TLZ12N0 V and TLZ12 8E V+V uC. gThe Allrounderg TLZ12D 23 V UC replaces the TLZ12M V+V uC. g The Simpleg . Also visit TLZ12D V +UC. Eltako Staircase time switch TLZplus 1; 2; 3; 4 Matching products. Eltako Staircase time switchTLZ Manufacturer, Eltako. Manufacturer.
|Published (Last):||28 March 2018|
|PDF File Size:||19.3 Mb|
|ePub File Size:||7.39 Mb|
|Price:||Free* [*Free Regsitration Required]|
Time settings between 0.
aslme78 | eBay Stores
A1, A7 and A8 need the same potential as L. Rltako passage switching to protect contacts and consumers. Only impulse switch functions: The MID covers a range of measuring instruments which include gas, water and active electrical energy meters.
The top rotary switch varies the off-delay time from 1 to 12 minutes.
Whenever several impulse switches are continuously energised make sure there is adequate ventilation as a function eltamo the calculated power loss. Technical data page A Only 1 watt standby loss.
If the light is switched on by holding down the push-button, it starts at the lowest brightness level after approx.
The electronics does not have an internal power supply and therefore no power is consumed in either the ON position or the OFF position. Now some of our electronic switchgear devices have this capability too.
Switch-off early warning and permanent light by push-button switchable. The relay is not switched on if the funtion HC is set. This is repeated three times at decreasing time intervals. Control voltage V. Control input with internally produced low voltage 24 V DC. Small loads up to mA, are acceptable and, once major loads are disconnected, they do uv prevent field disconnection. Function rotary switches4-wire circuit with attic lighting, resettableTypical connections3-wire circuit, resettableTechnical data page D8.
It will be synchronised at first operation.
Constant changes between sun and rain clouds would result in sensitive closing and opening of the shade elements. This is the setting ex works.
This closes output 5. Contact position indication with LED. Only dimmer switches with additional ESL marking are optimized for dimmable energy saving lamps.
Display up tlz12-8-230v 9,kWh with 3 decimal digits, from 10kWh with 1 deciaml digit and from kWh without decimal digit. This impulse group switch serves to implement commands generated by the sensor relays or by switches and push-buttons and controls a V motor for a shading element or a roller shutter.
Minimized standby loss of electronic devices supports international efforts to reduce energy consumption. FK Window contact FK Window contact The window contact as described above is also supplied as individual accessory item.
Руководства для переключателей и реле | Eltako
If the function STS is set, the lighting is switched on again after a power failure provided the set time has not yet elapsed. Supply voltage is same as the control voltage. With an internal toroidal-core current transformer the single phase AC current flowing through a consumer V1 of 0.
An LED lights up green when the supply voltage is applied and lights up yellow for rain. Every 4 seconds the display alternates between 3 whole numbers and 1 decimal point from 0. The starting operation is optimized and the dimm speed changes logarithmically.