APL 1A Low Dropout Fast Response Positive Adjustable Regulator and Fixed V, V and V. Features. Guaranteed Output Voltage Accuracy within. APLVC-TU 1A Low Dropout Fast Response Positive Regulator Fixed V and V 1A, Details, datasheet, quote on part number: APLVC-TU. APLUC-TU from Anpec Electronics Corp.. Find the PDF Datasheet, Specifications and Distributor Information.
|Published (Last):||10 August 2013|
|PDF File Size:||14.77 Mb|
|ePub File Size:||5.14 Mb|
|Price:||Free* [*Free Regsitration Required]|
In order to obtain lower dropout voltage and faster transient response, which is critical for low voltage applications, the APL has been optimized. Dropout voltage is guar- anteed at a maximum of 1.
APL Datasheet(PDF) – Anpec Electronics Coropration
Home – IC Supply – Link. For fixed voltage devices the top of R1 is internally connected to the output, and the ground pin can be qpl1117 to low side of the load. The device is available in an adjustable version and datashet output voltages of 1. Load regula- tion will be limited by the resistance of the wire con- necting the regulator to the load. X C should be approximately. On-chip thermal limiting provides protection against any combination of overload that would create excessive junction temperatures.
The data sheet speci- fication for load regulation is measured datasheey the output pin of the device. This will improve transient response as well as pro- mote stability.
X C should be approximately equal to R1 at ripple frequency ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and advise customers to obtain the latest version of relevant information to verify before placing orders. Simplified Application Circuits 1.
Dropout voltage is guar. When the adjustable regulator is used.
APL1117 Datasheet PDF
ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and. The output available volt.
For fixed voltage devices R1 and R2 are included in the device. Load Regulation When the adjustable regulator is used.
A low-ESR solid tantalum capacitor works extremely well and provides good transient re- sponse and stability over temperature. The data sheet speci. Best load regulation is obtained.
By plac- ing a resistor between these two terminals, a con- stant Current is caused to flow through R1 and down through R2 to set the overall output voltage. The output available volt- age range of an adjustable version is from 1. If R1 were con- nected to the load, RP is multiplied by the divider ratio, the effective resistance between the regulator and the load would be: Normally this current is chosen to be the specified minimum load current of 10mA.
Tantalum, or aluminum electrolytic capacitors can be used for bypassing. This will improve transient response as well as pro. Proper capacitor selection is important to ensure proper operation.
APL datasheet, APL datasheets, manuals for APL electornic semiconductor part
The APL is a low dropout three-terminal adjustable. Current limit is trimmed to ensure specified output current and controlled short-circuit current. On-chip thermal limiting provides. For fixed voltage devices the top of R1 is internally. The device is available.
Результаты поиска для APL1117-AH
Basic Adjustable Regulator ues will improve ripple rejection by bypassing the in- put to the regulator. Best load regulation is obtained when the top of the resistor divider R1 is tied di- rectly to the output pin of the device, not to the load.
The APL output capacitor selection is dependent upon the ESR equivalent daatasheet resistance of the output capacitor to maintain stability.